Qualcast rm32 Instruction Manual page 12

Usage
Attention: Do not operate the mower unless the deflector guard and
grass collector are fully installed. Risk of injury!
Fitting / removing the grass collector
E
- Lift the deflector guard (7)
- Place the grass collector on the mounting bracket at the back of the lawn
mower.
- Lower the deflector guard (7) onto the grass collector – a spring tensioner
holds it in place.
- To remove the grass collector, lift the deflector guard (7) and unhook the
grass collector from the mounting bracket. Ensure the deflector returns
down to its original position.
Adjusting the cutting heights
Important! Adjust the cutting height only when the motor is switched
off and the power cable has been disconnected.
1. Turn the mower on its side.
2. Pull the spring loaded axle towards you
3. Select a slot and insert the wheel axle
Ensure you use the same height setting for all 4 wheels.
Position
1
2
3
A higher cut height should generally be selected for the first cut
of the season.
Cutting height
20 mm
40 mm
60mm