Troubleshooting - Qualcast rm32 Instruction Manual

Trouble Shooting
Problem
Mower does not start
Motor stops
Untidy finish, motor
labours
Blade fails to turn
Strange noises, rattling
or vibrations
Possible Cause
No power at mains
socket
Defective on/off switch
Worn carbon brushes
Defective motor
Grass too long
Blade is blocked
Cut height too low
Blade blunt
Blade area blocked
Blade assembled
incorrectly
Blade blocked by grass
Blade screw loose
Blade screw loose
Blade damaged
Corrective Action
Check the switch,
socket, cable, wire and
have any repairs
carried out by an
electrician
Repair by a qualified
technician required
Set at a higher cut
setting. Lift the front
wheels slightly by
pressing down on the
handle bar.
Remove blockage
Set a higher cut height
Sharpen or replace the
blade
Remove blockage
Install the blade
correctly
Remove blockage
Tighten the blade
screw
Tighten the blade
screw
Replace the blade