Setting Up And Connecting The Refrigerator; Control Elements; Installing The Refrigerator - Waeco CoolMatic CRP-40 Operating Manual

CRP-40.book Seite 28 Donnerstag, 8. Oktober 2009 11:48 11

Setting up and connecting the refrigerator

5.1

Control elements

No. in
fig. 3, page 4
1
6 Setting up and connecting the
refrigerator
Safety instructions for installation on boats
a
Please note the following instructions for installation on boats:
– The device can be tilted sideways up to 30°. When setting up
the refrigerator, note that it must be fastened to take account of
this. If you have any questions regarding installation, consult
your specialist dealer.
– Install the refrigerator so that the warm air produced can easily
flow away (either upwards or to the sides, fig. 4, page 4).
– The appliance is designed for ambient temperatures between
+18 °C and +43 °C.
– If the appliance is powered by the mains, ensure that the power
supply has a residual current circuit breaker.
– Observe all the other installation instructions in this section.
6.1

Installing the refrigerator

In continuous operation, the air humidity may not exceed 90%.
Set up the fridge in a dry, sheltered place. Avoid placing it near heat sources
such as radiators, gas ovens or hot water pipes. Do not let it stand in direct,
strong sunlight.
The cooling device must be positioned so that heated air can dissipate easily.
Therefore make sure there is adequate ventilation (fig. 4, page 4).
No. in
fig. 4, Explanation
page 4
1 Hot waste air
2 Cold intake air
3 Condenser
4 With decorative panel 50 mm space at the top!
28
Explanation
Temperature controller
CoolMatic CRP-40