Controls And Starting A Wash - Fisher & Paykel DW60CE Installation Instructions And User Manual

Controls and starting a wash - CC models
20
Power/
Keylock
Press briefly to
power on or off
or press and hold
for 3 seconds to
activate/cancel
Keylock
To start a wash programme
Make sure that the dishwasher is powered on
1
Check that the wash programme displayed is the one you would like to use. If not, see section
2
'Changing the wash programme. '
Once the display shows the programme you would like to use, press
3
The display will show the approximate time remaining and the stage of the wash.
Note: the dishwasher will remember the last programme used.
To pause and restart a wash programme
Press to pause the programme.
1
Open the door very slowly.
2
Important!
There is a risk of being sprayed with hot water. Do not fully open the door until the spray arms have stopped
rotating.
Load, remove, or rearrange any dishes if needed.
3
Check that there is no excessive steam, then close the door.
4
Important!
If the programme is paused when the dishwasher has already heated the water, leave the door ajar for
several minutes before you close it again; if you don't, the expanding steam inside could force the door
open.
Press to restart the programme.
5
Start/Pause
Press to start or
pause a wash
programme
Scroll
Press to navigate
through menus
and options
.
Display
Shows settings,
options, wash
programme
status,
fault codes and
instructions
to start the programme.