Related Manuals for Dogtra 150NCP
Summary of Contents for Dogtra 150NCP
- Page 1 REMOTE CONTROLLED DOG TRAINING COLLARS OWNER’S MANUAL www.dogtra.com Copy right c 2002 Dogtra Company...
-
Page 2: Table Of Contents
CONTENTS OVERVIEW MAIN FEATURES SAFETY COLLAR PACKAGE CONTENTS DESCRIPTION OF TRANSMITTER PARTS DESCRIPTION OF COLLAR PARTS BATTERY CHARGER CHARGING THE BATTERIES TESTING YOUR COLLAR OPERATING INSTRUCTIONS TRAINING INFORMATION ACCESSORIES WARRANTY AND REPAIR INFORMATION... -
Page 3: Overview
OVERVIEW OVERVIEW training collars give you the ability to communicate with your dog in a timely manner even when the dog is at a distance from you. This makes it much easier for the dog to learn its lessons because late corrections are very confusing to the dog. -
Page 4: Main Features
OVERVIEW MAIN FEATURES MAIN FEATURES Pressing the “Constant” button causes the collar to emit electrical stimulation that stays on for up to twelve seconds as long as the COLLAR RECEIVER - Newly designed to button is held down. “Constant” stimulation is make adjusting the collar strap easy. -
Page 5: Safety
SAFETY PACKAGE INCLUDES SAFETY COLLAR PACKAGE CONTENTS collars use state-of-the-art micro- computer technology. Both the transmitter and Transmitter receiver have an automatic control which limits the stimulus to twelve seconds when Receiver used in the “Constant” mode. The nick mode gives the dog a momentary burst of Battery charger and splitter cable stimulation. - Page 6 TRANSMITTER transmitter Antenna Intensity Selection Dial Indicator Light Transmitter Antenna Nick Button has a 200 -yard range Pager Button with a 1.6 inch long fixed antenna. Constant Button...
- Page 7 Transmitter Battery Charging Receptacle Located on the side of the transmitter, the charging receptacle is covered by a rubber plug. Insert one end of the battery charging cable into the receptacle to charge the battery. (See Battery Charging Procedure.) Intensity Selection Dial The intensity selection dial is located on the After charging is completed, close the receptacle with its rubber plug to make sure dirt...
-
Page 8: Button Function
BUTTON FUNCTION BUTTON FUNCTION Nick Pager Constant Transmitter Indicator Light (LED) The transmitter indicator light is located The transmitter for has three between the antenna and the intensity selection buttons(two on the face of the transmitter and one on dial. the side.) On the face of the transmitter the top button gives When a button on the transmitter is pushed,... -
Page 9: Description Of Collar Parts
BUTTON FUNCTION COLLAR DESCRIPTION OF “Nick” Button COLLAR PARTS When the “Nick” button is pushed, the receiver emits an extremely short pulse of Collar electrical stimulation that automatically shuts off no matter how long you leave your finger on the button. - Page 10 COLLAR COLLAR On/Off Magnetic Switch Receiver Indicator Light (LED) Located on the front of the collar, the indicator To deactivate the hold the red light comes on and blinks once every 2 seconds line on the transmitter to the red line on the collar after the collar is turned on.
- Page 11 COLLAR COLLAR Receiver Charging Receptacle Contact Points Receiver Battery Charging Receptacle The collar should be fitted so that the On the inside of the collar, next to the collar stainless steel contact points press firmly against strap, is a battery charging receptacle with a the dog’s skin.
-
Page 12: Battery Charger
BATTERY CHARGER CHARGING THE BATTERIES BATTERY CHARGER CHARGING THE BATTERIES Charging Cable 220 volt Charger The battery charger and charging cables allow uses Ni-MH (Nickel-Metal-Hydride) you to charge both the transmitter and receiver at batteries that do not set a memory and can be the same time. - Page 13 CHARGING THE BATTERIES CHARGING THE BATTERIES Battery Charging Procedure 3. Fully charge the batteries for 14 hours if the collar is to be stored without use for a period 1. Attach the charging cables to both the of a month or more. transmitter and receiver(s), as shown on page 21.
-
Page 14: Testing Your Collar
TESTING TESTING TESTING YOUR 2. As a safety feature the will COLLAR automatically shut off if the constant stimulation button is depressed for 12 seconds or longer. To reset the unit, release the button for three seconds. 1. To activate the place the red line on the back of the transmitter to the red line on the collar. -
Page 15: Operating Instructions
OPERATING OPERATING OPERATING INSTRUCTIONS Intensity selection Fitting the collar To select the intensity level, start on the “zero” setting. Gradually increase the level until The collar strap should be adjusted so that the you get a response from the dog that would be contact points are held firmly against the dog’s equivalent to a quick pull or “JERK”... - Page 16 OPERATING MAINTENANCE Reception Maintenance collar has a range of Always clean and rinse the collar thoroughly 200 yards plus. Depending on the way you use with tap water after use in salt water. your transmitter, the transmitting range may vary. The receiver and collar strap should be You will have extended range if you hold the periodically cleaned with detergent and water to...
-
Page 17: Training Information
TRAINING INFORMATION TRAINING INFORMATION When the dog complies with the command use praise, as positive reinforcement. Getting Started With Your Dogtra Training Collar Beginning Electric Collar Training Before implementing any stimulation with the When you feel your dog understands the... -
Page 18: Accessories
TRAINING INFORMATION ACCESSORIES ACCESSORIES How Much Stimulation To Use Always start with low levels of stimulation The following items may be purchased and work your way up depending on the separately. personality of your dog and any given situation. By using only enough stimulation to get your point across, you will have a more controllable Dummy Collar environment and a dog that is under less stress. -
Page 19: Warranty And Repair Information
22912 Lockness Avenue daytime and evening phone numbers. Torrance, CA 90501 U.S.A. Ship to : 22912 Lockness Avenue Torrance, CA 90501 For any questions concerning your dogtra products call us Toll Free at 1-888-811-9111.
Need help?
Do you have a question about the 150NCP and is the answer not in the manual?
Questions and answers