Programming Example - NAPCO Gemini GEM-X255 Operating Manual

Reviewing a Programmed User Code
To review an existing User Code, enter the 2-digit user number and the corresponding User Code will display.
Exiting the User Program Mode
When you have completed programming or erasing User Codes, press

Programming Example

Program the User 30 Code to "3784":
1
Enter your User Code, followed by
2
Answer NO (press
The display will read "ENTER USER CODE"
3
Press
030
4 Press Jto save the code.
5
Press
C
Notes:
If the system contains more than one keypad, only the keypad designated "No. 1" may be used for programming (if in
doubt which is No. 1, ask your installer).
While in Program Mode, the ARMED and STATUS lights remain off and burglar and fire alarm functions are disabled.
In selecting your codes, do not program repetitive numbers (1111), consecutive numbers (1234), your birth date, address,
or other obvious combinations. Choose a code of up to six digits (a minimum of four is recommended, and required in UL
installations).If the keypad detects no Program Mode activity for more than 4 minutes, a tone will sound. Press
silence.
P R O G R A M M I N G ( O P T I O N A L )
A
) repeatedly until "ACTIVATE PROGRAM Y/N" is displayed, then press YES (
F
for User No. 30, then press
to exit the Program Mode.
.
A, A,
to exit the User Program Mode.
C
followed by
3784
).
E
.
to
C
23