NAPCO Gemini GEM-X255 Operating Manual page 7

S E T T I N G T H E A L A R M ( A R M I N G ) W H E N L E A V I N G
SYSTEM TROUBLE
SYS/TRBL
L O W B A T T E R Y
E02- 00 SERVICE
SYS/TRBL
P R E S S R E S E T K E Y
C A N ' T A R M S Y S T E M
SYS/TRBL
EXIT TIME 060
PLEASE LEAVE NOW
CAN'T ARM SYSTEM
AREA X IN TROUBLE
System Trouble
If you attempt to arm with a "SYSTEM TROUBLE" display alternating with an indicated trouble
code (e.g. "E02-00" (low battery); see SYSTEM TROUBLE ERROR CODES), a 3-second tone
will sound at the keypad. The window will display "PRESS RESET KEY, CAN'T ARM SYSTEM".
If you cannot correct the problem immediately, pressing
condition. Be sure to call for service as soon as possible.
Area Arming (Optional)
Some systems may be divided, or partitioned, into smaller independent subsystems, which
are referred to as Areas. In a system that has been partitioned into multiple areas, one or
more area may be armed while others remain disarmed.
Manager's Mode (Optional)
The Manager's Mode allows the user to arm / disarm other areas in a partitioned system. To
arm/disarm a different area:
1 Press the numerical key representing the other area number.
G
2 Press followed by
3 Enter your User Code followed by
4 Press G followed by
Global Arming (Optional)
To arm all areas simultaneously, press
To disarm all areas simultaneously, press
The User Code must be valid in all area(s).
If any zone is not secured, the keypad will display "CAN'T ARM SYSTEM, AREA X IN
TROUBLE", where X indicates the number of the Area in trouble. All faulted zones in the
respective area(s) must be secured or bypassed. Note: If a system trouble is indicated, the
system cannot be armed using this method.
C
J
. The keypad will now provide status and control of that area.
J
to arm or disarm the area.
J
to return to the home area.
and enter your code followed by
9 , G
0 G
,
will enable you to arm in this
and enter your code followed by
J
.
J
.
7