NAPCO Gemini GEM-X255 Operating Manual page 30

INTERIOR Button - Bypasses
Interior Zones on arming (see Zones -
Interior Zones).
Instant Protection - Arming without
entry delay using the
F
while remaining on the premises.
Keypad - Puts control-panel
functions at your fingertips. It can be
mounted anywhere in your premises.
Manager's Mode - In a partitioned
system, a low-security operating
mode that allows arming by area.
Panic Buttons - Blue buttons on the
keypad ( and
G 7
). If enabled, pressing
9
together with ,
7 8
will alert the central station of
9
a fire, auxiliary, or police emergency.
Partitioned System - A system that
has been subdivided into two or more
(up to eight) independent subsystems
(areas).
Pre-Alarm Warning. - A keypad
30
sounder alert of an impending
alarm. This option is programmable
by zone for the same duration as
that programmed for Abort Delay
(see Abort Delay).
button
Report - A transmission to a
central station notifying of a change
in the status of the system (alarm,
trouble, low battery, etc.).
RF Low Battery - (Wireless sys-
tems only) Weak transmitter
battery.
RF Check In - (Wireless systems
only) Periodic test report from
, or
8
transmitter (if a report is not
G
received on time, a supervisory-
or
failure system trouble will result).
Ringback - A beep after arming
verifying the central-station's receipt
of a closing report.
Service Code - A code intended
for temporary use.
Sounder - A local warning device
G L O S S A R Y
at each keypad to alert that (a) entry
delay has started; (b) an attempt was
made to arm with a zone in trouble;
(c) a Day-Zone condition exists (see
Zones: Day Zone); (d) 10 seconds
exit time remaining; (e) invalid code
entered; or (f) central station
acknowledged arming (see
Ringback).
System Trouble - A problem (low
battery, power failure, etc.) detected
in the system.
Trouble - A zone fault; an open
door, window, or other problem that
may prevent arming.
User Code - Your personalized
code for arming and disarming the
system. It may contain up to six digits.