Programming User Codes - NAPCO XP-400 Using Instructions

Your Installer has assigned a User 1 Code which may be used to not only Arm and Disarm the system, but
also to enter the User Program Mode, where you can program and/or reprogram up to 4 User Codes. The
following explains how you will use this code to program or erase additional user codes.
Entering the User Program Mode
A
Press
will flash, and the keypad will beep 4 times. You are now in the User Program mode.
ARMED
Zone lights 1 through 4will light to indicate any User Codes presently programmed.
READY
SYSTEM
Programming / Reprogramming User Codes
1
Press the User number to be programmed. (For example, press
The keypad will beep 2 times and the corresponding Zone light will flash to indicate the user
number you are about to program.
2
Press in the 4 digits of the new User 2 code, the keypad will beep 4 times.
ZONE 1
3
If there are more user codes to be programmed, return to step 1 above, otherwise, go to Exiting the
ZONE 2
User Program Mode below.
ZONE 3
Erasing a User Code
ZONE 4
1
Press the User number to be erased. The keypad will beep 2 times and the corresponding Zone light
will flash to indicate the user number you are about to erase.
2
D
Press
3
If there are more user codes to be erased, return to step 1 above, otherwise, go to Exiting the user
Program Mode below.
Exiting the User Program Mode
When you are done programming or erasing User codes, press
8
followed by and then enter the User 1 code. The Armed, Status and
. The zone light will go out to indicate that the user code has been erased.

Programming User Codes

ü ü
2
to program the User 2 code.).
A
to Exit the User Program Mode.
System Lights
11