Parts Supplied; Cavity Preparation - Fisher & Paykel DishDrawer DD24S Installation Instructions Manual

PARTS SUPPLIED

4
Drain hose Drain hose
support (1) joiner (1)
If the Drain hose(s) supplied are not long enough to reach your services, you must use a Drain Hose Extension Kit P/N 525798 which will extend the drain hose(s) by 11' 10" (3.6m). The kit is available from the nearest Fisher & Paykel
Authorized Service Agent, or Toll free 1.888.936.7872 or www.fisherpaykel.com.
5

CAVITY PREPARATION

Important!
Be sure the edges of the services hole are smooth or covered. If the services hole is through a metal
partition the hole must be protected with the Edge protector supplied to prevent damage to the
power cord or hoses.
These marks indicate formed bracket screw locations.
Note: To align drawer front to adjacent cabinetry, the product to countertop clearance can
be increased to 3 mm).
(
*
Preferred position. If adequate clearance, services hole can be higher.
If hole is higher, ensure drain hose(s) are routed straight into the waste connection.
Water Connection
Recommended HOT (Maximum 140°F/60°C).
Supplied hose to suit 3/8" (9 mm) male compression tting.
Water Pressure Max
Water softener models 1 MPa (145 psi)
Other models 1 MPa (145 psi)
Drains will need to be separated to satisfy kosher requirements. We suggest you con rm
acceptability with your local rabbi in respect to kosher installations.
Max. distance of
Left hand Right hand
hoses and cord from
side side
chassis edge
Drain hose
79" 71"
(2011 mm) (1794 mm)
Inlet hose
37" 53"
(1561 mm) (1344 mm)
Power cord
61" 28"
(936 mm) (719 mm)
Clamp (1)
Wire clip (1)
Min
0.1 MPa (14.5 psi)
0.03 MPa (4.3 psi)
Left hand Right hand
side side
Top mounting Phillips
brackets (2) 16 mm
screws (7)
If no side partition,
use a brace for
securing.
2" x 4"
(10 mm)
max. ø ½
1 " (38 mm)
*
Washer (1) Moisture protection
tape (1)
(to prevent moisture
damage)
N o t e : S e
Moisture
protection
e it h e r s id
tape must
be applied.
*
max.
17
(450 mm)
Important!
Adjacent cabinetry must not
extend above cavity base
Edge Protector (1)
(if service hole
partition is metal)
a t e d
n b e lo c
r v ic e s c a
.
D r a w e r ®
e o f D is h
"
Water supply
min.
7 "
(200 mm)
110-120 VAC
max. 15 A