Important Information For The Installation Of The Basic Kit - BMW 5 Series Saloon Installation Instuctions

1.

Important information for the installation of the basic kit

Only for use in the BMW dealer organisation.
The basic kit may only be installed by a specialist workshop that has the required special tools
and manuals (servicing, repair, diagnostics, etc.).
Ensure that the cables/lines are not kinked or damaged as you install them in the car.
Additional cables/lines that you install must be secured with cable ties/textile adhesive tape.
If the specified PIN's and chambers are occupied, bridges, double crimps or twin-lead terminals
must be used.
Item numbers refer only to the overview drawings and to the texts next to the appropriate figure.
The hands-free kit is only active if the ignition key is turned to position 1 (terminal R) or
further (from ignition key position 1 the telephone ON signal is simulated on the radio).
The radio then sends the telephone signals to the on-board speakers.
The interior trim parts supplied in the trim colour black are also available in other trim
colours and can be ordered using the electronic parts catalogue (EPC).
These installation instructions are only valid for cars
- without an on-board monitor radio with a production date after 9/00 or
- with an on-board monitor radio with a production date after 10/01.
The power supply wiring harness B is only required for BMW 5 Series touring (E39/2)
"
LHD cars.
Subject to technical modifications
Tools and requirement required
MoDIC III or DIS
Set of Philips screwdrivers
Set of flat screwdrivers
1/4 inch socket set
Set of Torx sockets
Angle cutter
Combination pliers
Retrofit/Installation kit No. 65 90 0 028 873 84 64 25,805 (others see cover sheet)
Installation Instructions no. 01 29 0 029 541 01 29 0 029 544
Cable lamp
Sharp knife
Set of drill bits 1 – 10 mm
Drill
Textile adhesive tape
Step drill, diameter 30 mm
Issue date: 04.2001
"
"
"
EN/3