Fujitsu ARU9RLF Service Instruction page 64

1-6. Setting the Indoor room temperature sensor switching function
(Only for Wired remote controller)
The following settings are needed when use the control by Wired remote controller temperature sensor.
Setting Description
No
Yes
If setting value is "00",
room temperature is controlled by the indoor unit temperature sensor.
If setting value is "01",
room temperature is controlled by either indoor unit temperature sensor or remote control unit sensor.
1-7. Setting the Remote controller signal code
Change the indoor unit Signal Code, depending on the remote controllers.
Setting Description
A
B
C
D
1-8. Setting the External input control
"Operation/Stop" mode or "Forced stop" mode can be selected.
Setting Description
Operation /Stop mode
(Setting forbidden)
Forced stop mode
( Factory setting)
Function Number Setting Value
42
( Factory setting)
Function Number Setting Value
44
( Factory setting)
Function Number Setting Value
46
03-03
00
01
00
01
02
03
00
01
02