Servicing Mode; Auto Off/On Button - Panasonic CS-NE7GKE Service Manual

13 Servicing Mode

13.1. Auto OFF/ON Button

This button is used to pump doen the air conditioner during servicing or transferring of outdoor unit.
1. It can be used to operate air conditioner in limited function if remote control is misplaced or malfunction.
• Auto operation will start when Auto OFF/ON Button is pressed and released within 5 seconds.
• Within 5 minutes of each operation, if the Auto OFF/ON Button is pressed again for more than 5 seconds the air conditioner
will switch to another operation after "Beep" sound.
2. The Auto OFF/ON button may be used together with remote control to set / change the advance setting of air conditioner
operation.
• Press and hold AUTO OFF/ON Button for more than 5 seconds, the air conditioner always operate force cooling operation.
• Press and hold AUTO OFF/ON Button until 2 Beep sounds are heard, the force heating operation is at standby condition.
• Press and hold AUTO OFF/ON Button until 3 Beep sounds are heard, the various setting mode is at standby condition.
• Press and hold AUTO OFF/ON Button until 4 Beep sounds are heard, the individual correspondence mode is at standby
condition.
• During standby condition, when the indoor unit receives "AC RESET" signal (Beep sound is heard) from remote control, the
corresponding mode will be activated.
3. REMOTE CONTROL NUMBER SWITCH MODE
The Remote Control Number Switch Mode will be activated if the Auto OFF/ON button is pressed continuously for more than
11 seconds (3 "beep" sounds will occur at 11th seconds to identify the Remote Control Number Switch Mode is in standby
condition) and press "AC Reset" button and press any button at remote control to transmit and store the desired transmission
code to the EEPROM.
For transmission code selection explanation, please refer to "Select Remote Control Transmission Code".
4. REMOTE CONTROL RECEIVING SOUND OFF/ON MODE
The Remote Control Receiving Sound OFF/ON Mode will be activated if the Auto OFF/ON button is pressed continuously for
more than 16 seconds (4 "beep" sounds will occur at 16th seconds to identify the Remote Control Receiving Sound Off/On
41