Related Manuals for Assa Abloy Liscio
Summary of Contents for Assa Abloy Liscio
- Page 1 Installation Guide ELECTRONIC KEYPAD LEVERSET WITH BLUETOOTH PROGRAMMING ASSA ABLOY, the global leader in door opening solutions...
-
Page 2: What's In The Box
What’s in the Box ITEM NO. DESCRIPTION QTY. Outside Trim Plate Assembly Adjustable Latch for 2 3/ 8 ” or 2 3/4” Backset Inside Trim Plate Assembly Inside Chassis Inside Trim Plate #8-32 x 3/ 8 " Flat Head Machine Screw 9V Alkaline Battery #8-32 x 11/2"... - Page 3 Preparation 1. Confirm Handing HANDING OF DOOR IS ALWAYS DETERMINED FROM THE OUTSIDE In-Swing Doors Out-Swing Doors outside outside Hinge is on the right. Hinge is on the left. Hinge is on the right. Hinge is on the left. Door is Right Hand (RH). Door is Left Hand (LH).
- Page 4 How to Install 1. Install Adjustable Latch Fasten Adjustable Latch using two #8 x 3/4” Wood Screws (item #6). To remove Pin: Scan QR code for Push Plastic Latch Pin (item #9) installation video through latch with screwdriver. Plastic The Adjustable Latch is factory Latch shipped with a 23/4”...
- Page 5 3. Install Outside Trim Plate Assembly Step 1: While holding Outside Trim Plate Assembly, Press the Plastic Extender (item #8) into end of Spindle Shaft. THIS SIDE ON TOP. Step 2: Position the Outside Trim Plate Assembly through the bore hole. ONCE POSITIONED, OUTSIDE TRIM PLATE ASSEMBLY REQUIRES...
- Page 6 4. Install Inside Chassis Step 1: Confirm the position of Cam Link. For Right Hand Locks: Turn to right position. CAM LINK MUST REMAIN IN THE CORRECT POSITION DURING INSTALLATION. For Left Hand Locks: Turn to left position. Step 2: Feed the Wire Harness through Inside Chassis.
- Page 7 Step 3: Fasten Inside Chassis using two #8-32 x 11/2” Flat Head Machine Screw (item #5). CHECK ALIGNMENT BEFORE FULLY TIGHTENING SCREWS. Step 4: Connect Wire Harness (A) and tuck Connectors as shown (B). Step 5: Install Battery. 9V Battery For optimal performance, always use a good quality battery.
- Page 8 ON USER MANUAL. Inside Correct position for installation. Thumbcam must be positioned Scan QR code for as shown (Neutral Position)* installation video *Neutral position is required for installation and removal of the Inside Trim Plate Assembly. Screws (item #4c) IN8-LISCIO-INST 08/04/2014...