Hitachi C 10FSH Safety Instructions And Instruction Manual page 15

5. Oblique angle
Before the power tool is shipped from the factory, it is adjusted for 0°, right angle, left 45° bevel cutting angle
and right 45° bevel cutting angle with the 8mm bolt (A), 8mm bolt (B) and the 8mm bolt (C).
When changing the adjustment, change the height of the 8mm bolt (A), 8mm bolt (B) or the 8mm bolt (C) by
turning them.
When changing the bevel angle to the right 45°, pull the fi xing pin on the direction shown in Fig. 12-a and incline
the motor head to the right.
When adjusting the motor head to 0°, always return the fi xing pin to its initial position as shown in Fig. 12-b.
Indicator
8mm Bolt (C)
(For left bevel
(Stopper for left 45°
scale)
bevel angle)
Fig. 12-a
6. Securing the workpiece
WARNING:
Always clamp or vise to secure the workpiece to the fence; otherwise the workpiece
might be thrust from the table and cause bodily harm.
7. Installing the holders ... (Optional accessory)
6mm Knob Bolt
(Optional accessory)
Steel
Square
Holder
(Optional
accessory)
6mm Wing Nut
(Optional
accessory)
Height Adjustment Bolt 6mm
(Optional accessory)
Fig. 13
8. Stopper for precision cutting ... (Stopper and holder are optional accessory)
Stopper
(Optional accessory)
Workpiece
Move
6mm Knob Bolt
(Optional accessory)
Fig. 14
Fixing Pin
Pull
The holders help keep longer workpieces stable and in place during the
cutting operation.
(1) As indicated in Fig. 13, use a steel square for aligning the upper
edge of the holders with the base surface.
Loosen the 6mm wing nut. Turn a height adjustment bolt 6mm, and
adjust the height of the holder.
(2) After adjustment, fi rmly tighten the wing nut and fasten the holder
with the 6mm knob bolt (optional accessory). If the length of Height
Adjustment Bolt 6mm is insuffi cient, spread a thin plate beneath.
Base Surface
Make sure the end of Height Adjustment Bolt 6mm does not protrude
from the holder.
The stopper facilitates continuous precision cutting in lengths of 11" to
17-3/4" (280mm to 450mm).
To install the stopper, attach it to the holder with the 6mm knob bolt as
Holder
(Optional
shown in Fig. 14.
accessory)
6mm Wing Nut (Optional accessory)
Height Adjustment Bolt 6mm (Optional accessory)
Indicator (For right bevel scale)
Return
Fixing Pin
Fig. 12-b
English
8mm Bolt (A) (Stopper for 0°)
8mm Bolt (B) (Stopper for right
45° bevel angle)
15