Practical Applications; Switch Operation - Hitachi C 10FSH Safety Instructions And Instruction Manual

English

PRACTICAL APPLICATIONS

WARNING:
* To avoid personal injury, never remove or place a workpiece on the table while the
* Never place your limbs inside of the line next to warning sign while the tool is being
Line

1. Switch operation

Lock-off Button
Hole
Fig. 23
WARNING:
2. Using the Vise Assembly (Standard accessory)
Screw Holder
6mm
Knob Bolt
V-Groove
Groove
Fence
6mm Knob Bolt
Fig. 24
CAUTION:
18
tool is being operated.
operated. This may cause hazardous conditions (see Fig. 22).
Warning Sign
The trigger switch lock-off button is designed to prevent inadvertent operation
of the power tool. To operate the power tool, it is necessary to fi rst fully insert
Handle
the lock-off button into the hole on the handle as shown in Fig. 23.
The trigger switch will not operate unless the lock-off button has been pushed
in.
When the trigger switch is released, the power goes off and the lock-off button
automatically returns to its initial position, locking the trigger switch.
Trigger
Switch
Always remove the lock-off button from the handle when the power tool is not in
use. This will ensure that the power tool cannot be turned on accidentally or by
someone (especially a child) who is not qualifi ed to use the power tool. If the lock-
off button is left in the handle, serious personal injury can result. Since the lock-off
button fi ts rather tightly, it may be necessary to turn it to the left and right during
mounting and removing.
The vise assembly can be mounted on either the left fence (Fence (B))
or the right fence (Fence (A)), and can be raised or lowered according
Knob
to the height of the workpiece.
To raise or lower the vise assembly, fi rst loosen the 6mm knob bolt. As
shown in Fig. 24, the vise shaft has three locking grooves into which
Vise
the tip of the 6mm wing bolt is designed to fi t in order to lock the screw
Plate
holder in the desired position.
To ensure that the tip of the 6mm wing bolt is properly aligned with the
desired locking groove on the vise shaft, simply align the upper surface
Work piece
of the fence to either of three v-grooves on the vise shaft surface or to
the lower surface of the screw holder.
Therefore, the vise assembly can be attached in either of three
positions to ensure proper height adjustment.
After adjusting the height, fi rmly tighten the 6mm wing bolt; then turn
the upper knob, as necessary, to securely attach the workpiece in
position.
Always confi rm that the motor head (see Fig. 1) does not contact the vise assembly
when it is lowered for cutting. If there is any danger that it may do so, loosen the
8mm knob bolt slightly and move the vise assembly to a position where it will not
contact the saw blade.
Warning Sign
Fig. 22
Line