Specifications; Applications; Charging Method - Hitachi UC 24YFB Instruction Manual And Safety Instructions

English

SPECIFICATIONS

Input power source
Charging time
Charger
Weight

APPLICATIONS

For charging the HITACHI batteries type EB2420.

CHARGING METHOD

NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
1. Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been inserted into the receptacle, pilot lamp will
blink in red. (At 1-second intervals)
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown in Fig. 2. Make sure the battery is fully
seated in the battery charger.
8
Single phase: AC120V 60Hz
Approx. 50 minutes ............. EB2420
Charging voltage ................. DC 24V
Charging current .................. DC 2.5A
1.3 lbs (0.6kg)
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
WARNING:
Do not use the electrical cord if damaged. Have it repaired immedi-
ately.