Kalorik MGR 38593 User Manual page 7

Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International USA. The
page must be reproduced and folded in order to obtain a booklet
A5 (+/- 148.5 mm width x 210 mm height). The page must be folded
in order to keep the good numbering when you turn the page of the
I/B. Don't change the page numbering. Keep the language integrity.
Print only what is inside the frame.
Then firmly screw on the sealing ring (16) by turning it clockwise
•
to tighten the feed screw (8), blade (9), and cutting plate (10)
(11) or (12) together. When screwing on the sealing ring, we
advise that you press the disc to make sure that its securing pin
stays in the right position.
Put the filling tray / hopper on the vertical feeding tube.
•
HOW TO GRIND FOOD
Cut the meat into pieces approximately 1" to 1 ½" in size and
•
put these pieces on the filling tray.
Plug the appliance into a wall outlet and switch it on with the
•
ON/OFF switch. The unit always needs to be on before adding
food!
Put a tray, a shallow plate, or a large bowl under the head to
•
collect the minced meat.
Place the meat in the food tray. Use pusher to feed the meat in
•
the tube, one piece at a time, and press when needed.
The pusher allows you to press the pieces of meat towards the
•
feed screw in order to lead the food towards the blade.
Note: Do NOT press too strongly, as you might block the appliance. If
this happens, see instructions below in paragraph "IN CASE THE
MOTOR IS BLOCKED OR CANNOT BE SWITCHED ON".
Note: during use, tighten the sealing ring regularly as necessary.
Once all the meat has gone through the grinder, turn the unit off,
•
unplug it. Remove the screw ring, the cutting plate, and the
cutting blade.
Depending on the type of meat, we advise that you let the
•
machine rest for approximately 30 minutes after each continuous
operation cycle of 10 minutes. The meat grinder can mince up 4
lb. of raw meat per minute (results may vary depending on the
type of meat and the cutting plate used).
7
Assembly page 7/48
MGR 38593 - 141121