Kalorik MGR 38593 User Manual page 6

Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International USA. The
page must be reproduced and folded in order to obtain a booklet
A5 (+/- 148.5 mm width x 210 mm height). The page must be folded
in order to keep the good numbering when you turn the page of the
I/B. Don't change the page numbering. Keep the language integrity.
Print only what is inside the frame.
ASSEMBLY OF THE ACCESSORIES AND OPERATION
Make sure that the power cord is unplugged and that the ON/OFF
switch is in the OFF position before assembling the accessories. This
should be observed each time you assemble or replace the
accessories.
Place the head (7) into the head inlet (4) with the vertical
•
feeding tube of the head placed at an angle.
Press the locking latch (2) and, while holding the head with one
•
hand, lock it tightly in place by turning clockwise.
Insert the feed screw (8) into the horizontal tube, inserting the
•
geared part first. Turn it slightly, if needed, until it is completely
inserted into the horizontal tube of the head (7).
Position the star shaped cutting blade (9) on the feed screw's
•
shaft.
Caution! It is very important to place the star-shaped blade in the
right position! The flat side shall be facing out, while the rounded
polished side shall be towards the feed screw. Failure to properly
position the star shaped blade will damage your appliance, the feed
screw, or the cutting plate!
Correct Way
Assemble the cutting plate of your choosing (10) (11) or (12).
•
According to the disc/plate you choose, you can mince meat
either coarsely or finely. Attach one of the 3 discs supplied onto
the blade, making sure that its pin locks precisely into the
corresponding notch on the head.
Incorrect Way!
6
Assembly page 6/48
MGR 38593 - 141121