Electrical Connection - Wolf M Series Installation Manual

INSTALLATION

Electrical Connection

WARNING
Verify power is disconnected from the electrical box
before proceeding.
If the electrical supply is located in the opening, electrical
connection must be made prior to placing the unit in the
opening. If the electrical supply is in an adjacent cabinet,
electrical connection can be made after placing the unit in
the opening. The conduit on the back of the unit allows for
a 3-wire or 4-wire installation.
Connect the black appliance wire to the black (L1)
1
power supply.
Connect the red appliance wire to the red (L2) power
2
supply.
Connect the bare appliance wire to the green/ground
3
wire.
For a four-wire system, seal the white/neutral wire with
4
a wire cap.
Installation
Place the oven in the opening and slide into position. To
ensure adequate depth for proper installation, the conduit
must fit into the recessed area along the rear edge of the
oven.
Locate the mounting hole in each side trim. Drill
holes and install #6 x 3 / " screws. Refer to the illustration
4
below.
Remove and recycle packing materials including the white
protective material behind each rack guide mounting
location.
MOUNTING
HOLE
Hole location.
1 / " pilot
(2)
16
|
wolfappliance.com 13