Installation; Electrical Connection; Troubleshooting - Wolf M SERIES Installation Manual

Hide thumbs Also See for M SERIES:

Design manual (116 pages)

Use and care manual (72 pages)

Use & care manual (68 pages)

Table Of Contents

Table of Contents

Available languages

Enlarged version

INSTALLATION

Preparation

Before moving the oven, protect any finished flooring and

secure the oven door(s) closed to prevent damage.

Use an appliance dolly to move the unit near the opening.

Place the appliance dolly on the side or back to prevent

damage. Remove and recycle packing materials. Do not lift

or carry the oven by the door handle.

OVEN DOOR REMOVAL

To lighten the load, the oven door(s) can be removed. Only

remove if necessary. Door removal should only be done by a

certified installer or service technician.

To remove, open the door completely. Rotate both hinge

latches forward to the open position, remove each screw

closest to the hinge, then lift the door up and out. Refer to

the illustration below.

To reinstall, insert door hinges into the frame openings, then

rotate hinge latches to the closed position.

SCREW

CLOSED

OPEN

Oven door removal.

WF Intl MOven IG 9002193B.indd 7

Electrical Connection

WARNING

Verify power is disconnected from the electrical box

before proceeding.

Open the terminal box to expose the screws with corre-

sponding numbers. Run the cord through the strain relief

hole and into the terminal box.

For Single Phase Install (Line, Neutral, Ground): Loosen

the 1, 5, and ground screws. Attach the Neutral wire to the

number 5 position. Line should be attached to the 1 position

and attach the ground to the corresponding ground screw.

For 3phase Install (L1, L2, L3, Neutral, Ground): Loosen the

1, 2, 3 and remove the copper bars. Loosen 5 and ground

screws. Attach L1 to position 1. L2 to position 2. L3 to posi-

tion 3. Neutral wire to position 5 and attach the ground to

the corresponding ground screw.

After tightening the screws, tighten down the cord strain

relief and close the cover to the terminal box without

pinching any of the wires.

IMPORTANT NOTE:

Connection of this appliance should be

through a fused connection unit or a suitable isolator, which

complies with national and local safety regulations. The

on/off switch should be easily accessible after the appli-

ance has been installed. If the switch is not accessible after

installation (depending on country) an additional means of

disconnection must be provided for all poles of the power

supply. When switched off there must be an all pole contact

gap of 3 mm in the isolator switch. This 3 mm contact dis-

connect gap must apply to any isolator switch, fuses and/or

relays according to EN60335.

Single phase wiring diagram.

3phase wiring diagram.

Installation

Place the oven in the opening and slide into position. To

ensure adequate depth for proper installation, the conduit

must fit into the recessed area along the rear edge of the

oven.

Locate the mounting hole in each side trim. Drill 2 mm pilot

holes and install #6 x 19 mm screws. Refer to the illustration

below.

Remove and recycle packing materials including the white

protective material behind each rack guide mounting

location.

MOUNTING

HOLE

Hole location.

Wolf, Wolf & Design, Wolf Gourmet, W & Design and the color red as applied to knobs are registered trademarks and service marks of Wolf Appliance, Inc. Sub-Zero, Sub-Zero &

Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, and Ingredients are registered trademarks and service marks of Sub-Zero,

Inc. All other trademarks or registered trademarks are property of their respective owners in the United States and other countries.