Refilling Water During Operation; Acess To Built-In Accessories - Hoover enhanced clean Owner's Manual

REFILLING WATER DURING OPERATION
• Turn paver switch off and unplug the power cord.
• Press down steam tdgger (4.8,A) to release
pressure. When tank is under pressure, the
safety pressure indicator will rise above the
surface of the cap (4.9,B). When the tank is not
under pressure the safety pressure indicator wi!l
be flush or below the su#ace (4.9,C).
= Wait 7-t0 minutes until the safety pressure
indicator has gone down, which indicates the
steamer has cooled, After 10 minutes, if the
safety pressure indicator has net fully dropped,
release residual steam pressure by pressing
trigger and then gently pushing the safety
pressure indicator. Slowly unscrew the water fill
safety cap counter-clockwise, but do not
remove. Allow machine to ¢0ol an additional 5
minutes. After you have ensured the steamer
has cooled and pressure has been released,
the water fill safety cap should turn freely for
removal. Unscrew the water fill safety cap
completely (4.10).
• Remove any remaining water to avoid overfilling,
insert funnel and add 1.1L (37oz) o_ clean water
(fill measuring cup to 550m1 (t8.50z) twice) and
pour the water into the tank (4.10). (Max, capacity
of the tank is 1.1L (37oz). Do not overfill the tank,
allow space to be left at the top).
• Re-install the water f_li safety cap in a clockwise
direction and tighten until completely sealed.
ACCESS TO BUILT-IN ACCESSORIES
II The steamer is fitted with a series of built
in accessories in the accessory holder
compartments on both sides of the main body_
II 4,1I To access these, press lightly on tabs (D)
on the top of side doors and swing doors down.