Optional Fiber Or Porcelain Liners; Glowing Embers - Empire Comfort Systems DVCP36PP30N-1 Installation Instructions And Owner's Manual

OPTIONAL FIBER OR PORCELAIN LINERS

Liners are not required for this fireplace, but add to the ambience.
Order one liner for a peninsula and two for a see-through.
NOTICE:
• This sequence may be used to install liners into either side
of the firebox.
• The fiber or porcelain liner(s) must be installed prior to
installing the log set on the burner.
• The fiber or porcelain liners sit in front (NOT behind) of the
brick brackets as shown in Figures 61 and 62.
1. From either side of the fireplace, remove the lower access
panel.
2. The two glass spring-latches are on the bottom of the glass
frame. Release them by pulling them away from the fireplace
and down. Remove the screen frame and glass frame as a
unit (separating them is not necessary) by lifting them up and
away from the fireplace. See Figure 60.
Figure 60
3. Set the brick bracket against the firebox wall as shown in
Figure 61.
Figure 61
Page 36
4. Screw the brick bracket to the false floor (but do not tighten)
with the screws shown on the left side of Figure 62 (Vent /
Pilot side liner only).
5. Use the self-drilling screws shown on the right side of Figure
62 to attach the brick bracket to the firebox wall.
1 2
Figure 62
6. Tighten the screws installed in step 4. (Vent / Pilot side liner
only).
7. Attach a second brick bracket to the top of the firebox wall
using two sheet metal screws as shown in Figure 63.
Figure 63
8. Set the bottom edge of the fiber or porcelain liner in front
of the bottom brick bracket (not behind) and tilt it into place
against the top brick bracket. See Figure 64.
9. Secure the fiber or porcelain liner in place using the
remaining hand-formed retaining bracket. Form the bracket
as shown and fasten it to the firebox top using a self-drilling
screw. See Figure 64.
Figure 64
36092-2-0316

GLOWING EMBERS

Install embers after installing the false floor of the fireplace, and
before the logs. Refer to the instruction manual supplied with
your Log Set or Mixed Log and Stones kit. Apply a single layer of
small "dime-sized" pieces of rock wool (glowing embers) in the
shaded areas shown below.
NOTICE:
• Pieces of glowing embers should be fluffed up prior to
placement onto the burner.
• Replacement of loose material (glowing embers) must be
purchased from an Empire Comfort Systems Dealer.
• Application of excess loose material (glowing embers) may
adversely affect performance of the fireplace. A single layer
of embers is to be used when applying Platinum Bright
Embers (in combination with production embers) to the
burner.
WARNING
All previously applied loose material must be removed
prior to reapplication.
TOP View - Ember Placement Shown in Shaded Area
36092-2-0316
Figure 65
Page 37