Table of Contents
Advertisement
Chapter 3
Setting up the TCP/IP Properties
This chapter describes how to configure the computer to communicate with the router.
Note:
Reboot your Windows system might be necessary after setting your computer function as a
DHCP client. In order to properly activate your choice, click OK to reboot your Windows
system.
3.1 Setting up the TCP/IP Properties
You could follow the instructions and configure the NIC installed on your system as a
DHCP client to get the IP address information automatically from the DSL router device.
3.1.1 Windows XP
The following describes the operation procedures in Windows XP.
Step 1
Choose Start > Control Panel > Switch to Classic View. The page as shown in
the following figure appears.
7
www.encore-usa.com
Advertisement
Table of Contents
