Trouble Shooting - Candy GOY 105 TXT User Instructions

What might be the cause of...
Defects you can remedy yourself
Before calling GIAS Service for technical advice please run through the following checklist. A
charge will be made if the machine is found to be working or has been installed incorrectly or used incorrectly.If
the problem persists after completing the recommended checks, please call the GIAS Service, they may be
able to assist you over the telephone.
FAULT
1. Does not function on any
program
2. Does not load water
3. Does not discharge water
4. Water on floor around
washing machine
5. Does not spin
6. Machine vibrates a lot
during spin
7. Door will not open
7. Display reads error
0, 1, 5, 7, 8, 9
8. Display reads error 2
9. Display reads error 3
10. Display reads error 4
74

Trouble shooting

CAUSE
Plug not in socket.
Not switched on.
Power failure.
Fuse blown.
Door open.
RCD tripped (trip switch)
Has the Delay start been set.
See cause 1.
Water supply turned off.
Program selector not correctly posi-
tioned.
Kink in discharge hose.
Foreign bodies in filter
The machine has been plumbed in
incorrectly.
Leaking gasket between tap and water
inlet hose.
Strand of clothing or dirt between door
rubber gasket and door glass.
Incorrect plumbing.
Water has not yet drained away.
"Spin Cancel" option selected (certain
models only).
Unbalanced load.
Washing machine not completely level. Adjust the special adjustable feet.
Load not distributed evenly.
Transit brackets not removed.
Two minutes have not elapsed since
the program finished.
-
No water fill.
No pump out.
Machine overfilled with water.
REMEDY
Plug it in.
Turn on mains switch
Check and refer to "Power Fail-
ure" section.
Check.
Close door.
Reset RCD.
Check.
Check.
Turn on water supply.
Position program selector
correctly.
Straighten discharge hose.
Examine filter.
Check installation.
Replace gasket and tighten con-
nection.
Re-load the machine and keep
rubber door gasket/door glass
clean.
Check plumbing.
Wait a few minutes for machine to
empty.
Check.
Rearrange load evenly.
Rearrange the laundry evenly.
Remove transit brackets (see
installation section).
Wait two minutes.
Call service.
Check water supplies are on.
Check drain is clear.
Check drain hose is not kinked.
Turn off water supply to machine.
Call service.