Kindcomfort KT012 Instructions For Use Manual page 25

4. Place the child seat on the vehicle seat facing forwards (4.4).
5. Insert the waist safety belt through the
the diagonal shoulder belt behind the child seat, insert the seat
belt in the vehicle anchor point and press until you hear a "click" so
that the child seat is properly installed (4.5).
6. Pass the diagonal shoulder belt through guide
anchor point and through guide
opposite side to the vehicle anchor point, making sure the waist
seat belt that passes through
4.7, 4.8 and 4.9).
7. Put inner cushion once more in place for Group 0 + and make sure
the vehicle's safety belt is taut and not twisted (4.10).
8. For greater space and to loosen the harness, it is necessary to
press L harness adjustment button, while simultaneously pulling
the harness straps towards you with your other hand (do not pull
the harness protector) (4.11).
9. Place the child in the child restraint seat making sure he is not
sitting on the harness or buckle protector. (4.12).
10. Join buckles in buckle-holder; insert both buckles in child seat
buckle-holder. You should hear a "click" when it has been properly
secured (4.13).
11. Pull harness adjuster
straps should lie comfortably on the child, without too much
slack. It should lie gently on the child without exerting pressure or
causing damage and the child should not be obliged to assume a
bad posture (4.14).
IMPORTANT
Always check that the harness straps are suitable for the height of
your child. The shoulders of the child should always be just below the
back slots at a suitable height (4.15).
Group 0+/1/2
B and round the seat belt on the
F guides is taut and not twisted (4.6,
M to snugly adjust harnesses, harness
F seat belt guides, pass
D on the side of the
www.kindcomfort.com
EN
25