Installing Child Seat. Group 1 - Kindcomfort KT012 Instructions For Use Manual

7. For greater space and to loosen the harness, it is necessary to
press L harness adjustment button, while simultaneously pulling
the harness straps towards you with your other hand (do not pull
the harness protector) (3.8).
8. Put inner cushion once more in place for Group 0 + and make sure
the vehicle's safety belt is taut and not twisted (3.9).
9. Place the child in the child restraint seat making sure he is not
sitting on the harness or buckle protector. (3:10).
10.Join buckles in buckle-holder; insert both buckles in child seat
buckle-holder. You should hear a "click" when it has been properly
secured (4:11).
11. Pull harness adjuster
should lie comfortably on the child, without too much slack. It
should lie gently on the child without exerting pressure or causing
damage and the child should not be obliged to assume a bad
posture (3:12).
Always check that the harness straps are suitable for the height of
your child. The shoulders of the child should always be just below the
back slots at a suitable height (3.13).

4. INSTALLING CHILD SEAT. GROUP 1.

WARNING
Installing the child seat forward facing can only be maid if the child
is more than 9 kg.
1. Recline the seat using handle
or 4 (it is advisable to choose an angle before installing the seat,
because to change it later it is necessary to readjust the harnesses
again) (4.1).
2. Open the harness system by pressing
seat buckle (4.2).
3. Remove the inner cushion but keep it handy to later put in place
(4.3).
24 Child restraint system
M to snugly adjust harnesses, harness straps
Only suitable for Group 1, approx.
9 months to 4 years (9-18 Kg.)
N placing the back in position 2, 3
H the red button on the child
KT012