Triggering The Flash - Bolt VB-11 User Manual

Triggering the Flash

There are five different ways to trigger the Bolt VB-11 and VB-22 flash units:
1. Hot Shoe: The flashes can be triggered by any standard hot shoe, such as a camera, off-camera cord or
radio receiver.
PC Cord: A PC sync socket can be attached to the flash units to trigger the flash. To use this function,
2.
open the rubber cover on the PC sync socket and insert a PC cord.
3.5 mm Mini Cable: The flash can also be triggered by using a 3.5 mm mini cable flash sync cord.
3.
Simply open the rubber covering on the flash's sync jack, insert one end into the jack and the other end
into a flash triggering device.
Optical Slave: Both flashes can be used as wireless slave units in single or multiple flash configurations.
4.
To use the slave mode, see the Optical Slave Triggering Mode section of this manual on page 21.
Dedicated Remote Control: A dedicated remote control, such as the Impact ControlSync 16 Transmitter
5.
and Receiver (sold separately), can control triggering, adjust power levels, and turn the AF-Assist and
Audio modes on and off. To use the remote, plug the dedicated receiver into the wireless control port on
the side of the flash.
Triggering the Flash
|
19