Pppoe (Dsl) - eHome EH100 User Manual

Section  - Configuration
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide
you with a username and password. This option is typically used for DSL services. Make sure to remove your PPPoE
software from your computer. The software is no longer needed and will not work through a router.
PPPoE:
Select Dynamic (most common) or
Static. Select Static if your ISP assigned
you the IP address, subnet mask,
gateway, and DNS server addresses.
User Name:
Enter your PPPoE user name.
Password:
Enter your PPPoE password and then
retype the password in the next box.
Service Name:
Enter the ISP Service Name (optional).
IP Address:
Enter the IP address (Static PPPoE
only).
DNS Addresses:
Enter the Primary and Secondary DNS
Server Addresses (Static PPPoE only).
Maximum Idle
Enter a maximum idle time during which
Time:
the Internet connection is maintained
dur ing inactivity. To disable this
feature, enable Auto-reconnect.
MTU:
Maximum Transmission Unit - you may
need to change the MTU for optimal
performance with your specific ISP. 1492
is the default MTU.
Connection Mode
Select either Always-on, Manual, or
Select:
Connect-on demand.
eHome EH100 User Manual
Internet Connection Setup

PPPoE (DSL)