Mercury 135 Verado Manual page 63

FEATURES AND CONTROLS
1. Place active remote control lever to idle position.
2. Proceed to the inactive helm and position remote control lever
to the idle position.
3. Press throttle only/station select button two times. The
"ACTIVE" light will illuminate to indicate the remote control is
in control of the engine.
a
a - Active light
4. The "ACTIVE" light will switch off at the original helm.
Synchronizing Helms Prior To Helm Transfer
Pressing the throttle only/station select button one time allows the
boat operator 10 seconds to match up the control handle setting
at the new station with the handle setting that is at the old (to be
inactive) station. If the handle is not matched, the neutral light will
flash. The light blinks faster as the handle is nearing match
position. Once the light stays on continuously, the handle is
matched and the throttle only/station select button can be pressed
again to complete the transfer. This completes the transfer
process, and give control to the new station. If the helm transfer is
not completed within 10 seconds, the helm transfer is cancelled.
b
ACTIVE
THROTTLE
ONLY
STATION SELECT
55
a
SYNC
ACTIVE
THROTTLE
ONLY
STAT ION SELECT
b - Throttle only/station
select button
b
22753