Storage; Disposal - Zenoah EBZ3000RH Owner's Manual

9. Maintenance
AIR INLET NET
IMPORTANT
• Blowing air is taken in from the air inlet net. When air
flow has dropped down during operation, stop the
engine and inspect the air inlet net for blocking by
obstacles.
• Note that failure to remove any such obstacles may
result in the engine becoming overheated and dam-
aged.
(1)Net
WARNING
Never use the blower without the net of the blower.
Before each use, check that the net is attached in
place and is free from any damage.
IGNITION COIL AIR GAP INSPECTION
• If the gap is out of standard or when installing the coil
or rotor, adjust the air gap between the ignition coil
and the iron core of the rotor.
Air Gap:
0.40mm (0.35 ~ 0.45mm)
0.016" (0.014 ~ 0.017")
(1) Rotor
(2) Ignition coil
SHOULDER STRAP
• If the shoulder strap is damaged it may break during
use, thus causing the product to fall and resulting in
personal injury. Follow the instructions below to re-
place the shoulder strap with new one.
1. Hook the upper part of the shoulder strap at the notch
on the top of the frame and pass it through the buckle
as shown in the figure, then secure it firmly.
2. Put the hook at the lower part of the shoulder strap in
the strap installing location at the bottom of the frame.
(1)
(2)
(1) Buckle
(3) Hook

10. Storage

BEFORE STORING THE BLOWER:
1. Drain a fuel tank and push the primer bulb until it be-
comes empty of fuel.
2. Remove the spark plug and drop a spoonful of 2-cycle
oil into the cylider. Crank the engine several times and
install the spark plug.
3. Store unit in a dry, dust free place, out of the reach of
children.

11. Disposal

When disposing your machine, fuel or oil for the machine,
be sure to allow your local regulations.
EBZ3000RH
(3)
(4)
(2) Frame
(4) D-ring
GB-13
G
B