Page 2
COUNCIL’S DIRECTIVE. The products referred to are : DESIGNATION : BLOWER (Back-pack garden blower) MANUFACTURER : Husqvarna Zenoah Co., Ltd. MODELS : EBZ4800 : EB7000 SERIAL NUMBERS DATING : 2010 and onwards...
Page 3
EBZ4800 / EB7000 EXPLANATION OF SYMBOLS AND SAFETY WARNINGS EBZ4800 WARNING!!! RISK OF DAMAGING HEARING Wear head, eye and ear protection. EB7000 WARNING!!! RISK OF DAMAGING HEARING Wear head, eye and ear protection. MODEL DISPLACEMENT SOUND LEVEL VIBRATION LEVEL 2000/14/EC...
Operator’s manual. 10. Husqvar na Zenoah has a a) Keep your body warm. Never use policy of continuous product blower during rains. development and therefore re- b) Wear thick anti-vibration gloves.
Page 7
EBZ4800 / EB7000 5. For safe operation Limit the amount of time over 8. The ignition system of your unit which the product is to be used produces an electromagnetic continuously to somewhere field of a very low intensity. This...
Page 8
ZENOAH servic- ing dealer for assistance. Check- 6. The blower must not be used ing the fan is very important. If the while on a ladder or scaffolding.
Page 9
5. When replacing the any other part, or any lubricant, always be sure to use only ZENOAH prod- ucts or products which have been certified by ZENOAH for use with the ZENOAH product.
EBZ4800 / EB7000 6. Set up FLEXIBLE HOSE and SWIVEL JOINT 1. Connect the blower and swivel joint with flexible hose. Clamp both ends of the flexible hose securely with the hardware supplied with the unit. (1) Flexible hose (2) Swivel joint...
2-cycle gasoline engine use. 2. Put fuel into the fuel tank to 80% of the full capacity. If Zenoah oil is not available, use an anti-oxidant added 3. Fasten the fuel cap securely and wipe up any fuel quality oil expressly labeled for air-cooled 2-cycle spillage around the unit.
EBZ4800 / EB7000 8. Operation STARTING ENGINE 6. Once the engine is running, gradually open the choke if it was set closed, and let the engine run at idle speed IMPORTANT for a minute to warm it up. • Avoid operating the blower with the flexible tube and NOTE swivel joint disconnected.
EBZ4800 / EB7000 9. Maintenance Maintenance, replacement, or repair of the emission control device and systems may be per- formed by any non-road engine repair establishment or individual. Daily Every Every Every System / Compronent Procedure 25 hours 50 hours 100 hours...
Page 14
EBZ4800 / EB7000 9. Maintenance REPLACEMENT PLUG EBZ4800: NGK CMR7H / CHAMPION RZ7C [EB7000] EB7000 : CHAMPION RCJ6Y 1. Unscrew 2 knob bolts and remove the air cleaner cover. Then remove a prefilter mounted inside the air cleaner IMPORTANT cover.
EBZ4800 / EB7000 9. Maintenance PROCEDURES TO BE PERFORMED AFTER EV- HARNESS ERY 100 HOURS OF USE If the harness is damaged it may break during use, thus 1. Remove the muffler, insert a screwdriver into the vent, causing the product to fall and resulting in personal in- and wipe away any carbon buildup.
→ clogged with dust → clean When your unit seems to need further service, please consult with our ZENOAH service shop in your area. Limited warranty Should any failure occur on the product under normal oper-...
Need help?
Do you have a question about the EBZ4800 and is the answer not in the manual?
Questions and answers