Operation - Zenoah EBZ3000RH Owner's Manual

EBZ3000RH

8. Operation

STARTING ENGINE
IMPORTANT
• Avoid operating the blower with the flexible tube
and swivel joint disconnected. That will reduce the
cooling air and the engine could be damaged by
overheating.
1. Push the primer bulb until fuel flows out in the clear
tube.
2. When the engine is cool, close the choke.
3. Set the ignition switch to the start position.
(1)Full Throttle
(2)Idling
(3)Ignition Switch
4. Set the throttle lever in idling position.
5. To start, hold the top of the blower firmly with your left
hand. Pull the starter knob slowly until you feel it en-
gage and then give it a vigorous strong pull.
IMPORTANT
• Avoid pulling the starter rope out to its full extent
and allowing the starter rope to snap back. This
will prevent premature damage to the starter.
• Do not let a person stand near the blower or the
GB-10
(1)Primer Bulb
(1)Choke Lever
(2)CLOSE
(3)OPEN
(3)
(1)
(2)
exhaust port.
• Never touch the muffler, spark plug, other metallic
parts of the engine or engine cover while the en-
gine is in operation or immediately after shutting
down the engine. These metallic parts and engine
cover reach high temperatures during operation
and doing so could result in serious burns.
6. Once the engine is running, gradually open the choke
if it was set closed, and let the engine run at idle speed
for a minute to warm it up.
NOTE
When the engine fails to start after several attempts due to
overchoking, open the choke and repeat pulling the rope.
ADJUSTING IDLE SPEED
• The idling speed is set for 3000 rpm at the factory. If it
is necessary to adjust the idle speed, use the adjust-
ment screw on the top side of carburetor.
(1)Idling
Adjustment Screw
STOPPING ENGINE
• Move the throttle lever to the idling position and set
the ignition switch to the stop position.
(1)Ignition Switch
NOTE
If the engine won't stop when setting the ignition switch
to the stop position, close the choke lever and stop
the engine.
In this case, please repair the machine at your nealest
servicing dealer.
(1)
(1)
(1)Choke Lever
(2)CLOSE
(3)OPEN