Pride Icon Owner's Manual page 25

V . B A T T E R I E S A N D C H A R G I N G
BATTERY REPLACEMENT
To change a battery in your scooter:
WARNING! Batter y posts,
ter minals
accessories contain lead and
lead compounds. Wash hands
after handling.
WARNING! Prevent injury and/
or equipment damage! Do not
mix or match new and old
batteries. If you encounter a
situation where one battery
needs to be replaced, then
replace both batteries. Refer
to specifications table in this
manual and
supplied with the batter y
charger for recommended type
and capacities.
1. Power down your scooter and remove the key.
2. Remove the seat.
3. Gently lift the rear shroud off of your
scooter high enough to be able to dis-
connect the rear lighting harnesses. See
figure 12.
4. Disconnect the battery tie-down strap.
5. Disconnect the t-handle battery harness
from the battery harness mating plug. See
figure 12A.
6. Disconnect the battery cables from the bat-
tery terminals.
7. Remove the old batteries.
8. Place new batteries in the battery wells.
9. Connect the red battery cables to the posi-
tive (+) battery terminals.
10. Connect the black battery cables to the
negative (-) battery terminals.
11. Reconnect the battery harness to the bat-
tery harness mating plug. See figure 12A.
12. Reconnect the battery tie-down strap.
13. Reconnect the rear lighting harnesses.
14. Reinstall the rear shroud and the seat.
NOTE: If you encounter a damaged or cracked battery, immediately enclose it in a plastic bag and call
your authorised Pride Dealer for instructions on disposal. Your authorised Pride Dealer will also have
the necessary information on battery recycling, which is our recommended course of action.
Icon
and related
the manual
www.pridemobility.com
Figure 11. Charger Power Lead Receptacle
REAR
LIGHTING
HARNESSES
Figure 12. Disconnect Lighting Harnesses
Figure 12A. T-Handle Battery Harnesses
T-HANDLE BATTERY
HARNESSES
25