Programming the transmitter and receiver
1. Connect the receiver to a wall socket.
2. Hold in [ON/OFF Learning Code] on the receiver for 5 seconds until the LED (1)
starts flashing.
3. Hold in [OFF] on the transmitter for 2 seconds (until the LED on the receiver goes
off) for the channel you wish to use on the receiver. If [OFF] is released too early,
the programming will not work.
Note: Do not press the buttons on the transmitter too hard; light pressure (just enough
to light up the LED on the transmitter) is all that is needed. If you press too hard
the programming will not work.
Operation
•
Press [ON] or [OFF] for the selected channel (1–4) on the transmitter to turn on
or off the electrical devices connected to the receiver on that channel.
•
Press [ALL OFF] or [ALL ON] to activate or deactivate all the receivers at
the same time.
Specifications
Battery
A23, 3LR50, V23GA (12 V)
433.92 MHz
Frequency
Up to 70 metres (unobstructed)
Range
Receiver EMW100R (36-1859)
Description
•
Wireless transmitter and receiver, easy to set up and use.
•
Range up to 70 metres if unobstructed.
•
A red LED on the receiver comes on when it has been turned on by the transmitter.
The LED goes off when the receiver is turned off.
•
The programmed channel is permanently saved in the memory.
4