Pin Assignment Of Internal Ports - Fujitsu Siemens Computers D1627 Technical Manual

Pin assignment of internal ports

The pin assignment of some internal connections is shown in English in the following.
i
Some of the following connectors may be optional!
Front panel
Watch the poling of the LEDs. The positive pole
of the connection cables is often indicated with a
coloured wire.
Connection
Reset
Sleep This connection is reserved for future use.
Power On/Off
HD LED
SCSI Activity Attention: Do not connect to the LED connections of an SCSI controller! This
Input connection is intended for a cable with a 4-pin connector. An SCSI controller
reports activity (low-active) via this cable.
Message LED
Power On LED Indicates the system state APM or ACPI together with the Sleep LED (see
chapter entitled "APM and ACPI system status, energy-saving modes").
Sleep LED Indicates the system state APM or ACPI together with the Power-On LED (see
chapter entitled "APM and ACPI system status, energy-saving modes").
Serial ATA (internal)
Pin
1
3
5
7
A26361-D1627-Z120-1-6319
Signal
GND
Transmit data negative
Receive data negative
GND
Pin assignment of internal ports
Power On/Off Message LED 1)
1)
Sleep
1)
HD-LED
1)
Reset
SCSI LED Input
1) Cable is not included in the delivery scope.
2) The same interface
3) 2pin or 3pin connector possible
Note
Pin
2 Transmit data positive
4
6 Receive data positive
8
Sleep LED
Power On
LED 1) 3)
1
2
1) 2)
1
Signal
GND
Key
English - 11