Radio Alarm; Radio Operation; Waveband Selection - Sangean PR-D3L Instruction Book

RADIO ALARM

(1) Select the Radio Alarm mode by pressing alarm mode button.
(2) If radio alarm is selected, when the alarm is on, the radio will
play the last station selected.
HWS ALARM
A repeating beep tone will sound when using HWS alarm.
The alarm beep will increase in volume every 15 seconds for one
minute followed by 1 minute silence before repeating the cycle.
The HWS alarm will sound for one hour unless turned off by
pressing the POWER button.
SNOOZE
When the alarm is on, press any buttons except POWER button,
the alarm will be in Snooze function for an interval of 5 minutes
before pressing POWER button to turn it off. Display will flash
Snooze symbol and alarm status.

RADIO OPERATION

WAVEBAND SELECTION

There are three wavebands in PR-D3L unit
Waveband Frequency
FM 87.50 - 108 MHz
MW 522 - 1710 kHz
LW 144 - 279 kHz
There are 4 different available tuning methods:
Manual tuning, Rotary tuning, Scan tuning and Memory recall tuning.
9
Aerial Type
Telescopic
Fully extend the aerial,
angle and rotate for best reception.
Internal
Rotate for best reception.
same as MW