Download Print this page

Makita HM0871C Technical Information page 10

Hide thumbs Also See for HM0871C:

Advertisement

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-5 Crank shaft
DISASSEMBLING
(1) Separate Barrel from Crank housing as per the left illustration in Fig. 15.
(2) Remove Crank cap, Seal ring Air pipe and Flat washer 34 from Crank housing as per the left illustration in Fig. 16.
(3) Remove Piston together with Connecting rod as per the center and right illustrations in Fig. 16.
(4) remove Crank shaft as illustrated in Figs. 19 and 20.
Fig. 21
Crank shaft can be removed
as illustrated below.
M8x40 Hex
Socket head bolt
(5) Lock Armature, and set 1R139, Flat washer 8 and M8x40 Hex socket head bolt as illustrated in Fig. 20 again,
tighten the M8x40 Hex socket head bolt with Hex wrench. So Ball bearing 6203LLU are removed as illustrated
in Fig. 22. If it is difficult to remove as illustrated in Fig. 22, remove Ball bearing 6203LLU as illustrated in Fig. 22A.
Fig. 22
Crank shaft
Ball bearing 6203LLU
Remove Retaining ring
R-40 with 1R005.
Retaining ring R-40
Flat washer 8
Fig. 22A
M8x40 Hex
socket head bolt
Flat washer 8
Loosening M8x40 Hex socket head bolt
halfway, insert Crank shaft into the remaining
Ball bearing 6203LLU by tapping the M8x40
Hex socket head bolt.
Setting 1R132 into the inner ring
of Ball bearing 6203LLU, pull off
Ball bearing 6203LLUwith 1R089.
Ball bearing 6203LLU
P 10/ 17
1R089
1R132

Advertisement

loading

This manual is also suitable for:

Hm0870c