Download  Print this page

Advertisement

INSTRUCTION MANUAL
Demolition Hammer
HM0871C
HM0870C
010450
DOUBLE INSULATION
IMPORTANT: Read Before Using.
1

Advertisement

Table of Contents

   Summary of Contents for Makita HM0871C

  • Page 1 INSTRUCTION MANUAL Demolition Hammer HM0871C HM0870C 010450 DOUBLE INSULATION IMPORTANT: Read Before Using.
  • Page 2: Specifications

    • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Specifications may differ from country to country. • Weight according to EPTA-Procedure 01/2003 END201-4 For Model HM0871C ENG102-3 Symbols Noise The following show the symbols used for the equipment.
  • Page 3 Keep children and bystanders away while Makita Corporation responsible operating a power tool. Distractions can cause manufacturer declare that the following Makita you to lose control. machine(s): Electrical safety Designation of Machine: Power tool plugs must match the outlet. Never Demolition Hammer modify the plug in any way.
  • Page 4 Personal safety dangerous in the hands of untrained users. Stay alert, watch what you are doing and use 22. Maintain power tools. Check for misalignment common sense when operating a power tool. or binding of moving parts, breakage of parts Do not use a power tool while you are tired or and any other condition that may affect the power tool’s operation.
  • Page 5: Functional Description

    Always be sure that the tool is switched off and • the speed adjusting function may no longer work. unplugged before adjusting or checking function on the tool. For Model HM0871C only Switch action NOTE: 1. Switch lever Blows at no load per minute becomes smaller than •...
  • Page 6 Indicator lamp For tool with D-shaped side handle 1. D-sided side 1. Power-ON handle indicator lamp 2. Clamp nut (green) 2. Service indicator lamp (red) 010453 010456 The side handle can be swung 360° on the vertical and The green power-ON indicator lamp lights up when the secured at any desired position.
  • Page 7 It should be slide the change ring back to the original position. The lubricated every time the carbon brushes are replaced. bit will be secured in place. Send the complete tool to Makita Authorized Service Center for this lubrication service.
  • Page 8 Wipe out the old grease inside and replace with a fresh Plastic carrying case • grease (30 g). Use only Makita genuine hammer grease (optional accessory). Filling with more than the specified amount of grease (approx. 30 g) can cause faulty...
  • Page 12 Makita Corporation Anjo, Aichi, Japan www.makita.com 884928C224...

This manual is also suitable for:

Hm0870c

Comments to this Manuals

Symbols: 0
Latest comments: