Makita HM0871C Technical Information page 17

W
iring diagram
Fig. D-3
Pass the Lead wires of Lead unit through Polyethylene tube illustrated below.
Connector
Fig. D-4
The Lead wires have
to be tightened in this
area.
Connector of
Lead unit
Lead Unit
Polyethylene Tube Ø8-30
Handle
Put the following Lead wires
of Lead unit into Sponge sheet.
* Lead wire (black) for connecting to Switch
* Lead wire (black) for connecting to Terminal
block
* Lead wire (white) for connecting to Switch
Sponge sheet
Terminal block
Polyethylene
tube
for connecting to Switch
for connecting to Terminal block
Lead unit's Lead wires bundled
with Polyethylene tube has to put
under Terminal block.
Boss
Lead unit's Lead wires
Lead unit's Lead wires have to
be put on both side of Boss,
And connect them to Switch
and Terminal.
P 17/ 17