When Installing The Aerial Inside The Vehicle (On The Dashboard Or Rear Shelf) - Pioneer SPH-DA02 Installation Manual

Hide thumbs Also See for SPH-DA02:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Section
03
Installation
When installing the aerial inside the vehicle (on the dashboard or
rear shelf)
WARNING
Do not install the GPS aerial over any sensors or vents on the dashboard of the vehicle, as
doing so may interfere with the proper functioning of such sensors or vents and may compro-
mise the ability of the double-sided tape under the GPS aerial to properly and securely affix to
the dashboard.
Affix the double-sided tape on the surface as
level as possible where the GPS aerial faces
the window. Place the GPS aerial on the dou-
ble-sided tape.
Note
Some models use window glass that does not
allow signals from GPS satellites to pass
through. On such models, install the GPS aer-
ial on the outside of the vehicle.
18
Engb
Double-sided tape
Peel off the protective sheet.
GPS aerial
Make sure the surface is free of
moisture, dust, grime, oil, etc.,
before affixing the double-sided
tape.
Note
The double-sided tape
contains a strong adhesive
which may leave a mark on
the surface if it is removed.
Clamps
Use separately sold clamps
to secure the lead where necessary
inside the vehicle.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sph-da01

Table of Contents