Battery Charge Level Indicator; Circuit Breakers; Solution Control Lever - Windsor SC20 10052190 Operating Instructions Manual

1. Brush Switch
Controls the scrub brush motor.
To turn scrub brush on, press the top of the switch.
To turn scrub brush off, press the bottom of the switch.
2. Brush Lift Lever
Raises and lowers the brush.
To lower the brush, lift the lever from the notch, move to
the left, then lower.
To raise the brush, lift the lever from its lowered
position.
3. Vacuum Switch
Controls the vacuum motor.
To start vacuum motor, press the top of the switch.
To stop vacuum motor, press the bottom of the switch.
4. Squeegee Lift Lever
Raises and lowers the squeegee.
To lower the squeegee, lift and pull the lever to the left
and then lower.
To raise the squeegee, lift the lever and push it to the
right.

5. Solution Control Lever

Controls solution flow to scrub deck.
To increase flow pull and raise the knob to the desired
flow.
To decrease flow push the knob down.
86400640 Operator's Manual - Saber Compact 20

6. Battery Charge Level Indicator

Indicates the charge level of the batteries.
The meter display is divided into 10 vertical bars. Bars
illuminated on the far right indicate full charge. Bars
flashing near the left side indicate the batteries should
be recharged. Further operation of the machine could
damage the machine or the batteries.
When the machine is left overnight with less than a full
charge, the display may initially indicate a full charge. It
will also indicate a full charge if the batteries are
disconnected, then reconnected. After a few minutes of
operation the meter will give the correct charge level.
7. Hour Meter (Optional)
Records the number of hours the machine's brush has
been in operation. This information is useful in deter-
mining when to service the machine.

8. Circuit Breakers

Circuit breakers interrupt the flow of power in he event
of an electrical overload. When a circuit breaker is
tripped, reset it by pressing the exposed button. If a
circuit breaker continues to trip, the cause of the elec-
trical overload should be found and corrected.
30 amp. Protects the vacuum
motor.
30 amp. Protects the scrub brush
motor.
Operations
15