Table Of Contents - HP DAT 40e Getting Started Manual

External drives - contents
Pre-Installation
Before you start
Backup software and drivers
Using the CD-ROM
Checking the SCSI connection
Installing the tape drive
Step 1: Check the drive's SCSI ID
Step 2: Set the configuration switches (UNIX systems)
Step 3: Connect the SCSI cable
Step 4: Connect the power cable
Step 5: Verify installation
Using the tape drive
Your HP StorageWorks DAT tape drive
Use the correct media
Register your tape drive
Using HP OBDR
Diagnostic tools
Optimizing performance
Troubleshooting
Problems with cartridges
Other sources of information
page 3
page 5
page 7
page 9
page 11
page 13
page 15
page 17
page 19
page 21
page 23
page 25
page 27
page 29
page 30
page 31
page 35
page 37
1