DeWalt D28112 Instruction Manual page 19

1.Allowtoolto reach fullspeed FIG. 21
beforetouching tool to work
surface.
2.Apply m inimum p ressure towork
surface, allowing toolto operate
at highspeed. C utting rateis
greatest when thetooloperates
athigh speed.
3.Once a cutisbegun a nd a notch
is established in theworkpiece,
do notchange t heangle of the
cut. C hanging the angle w ill c ause
the wheel tobend a nd may cause
wheel breakage.
4.Remove thetool f rom work surface before turning t ool o ff. A llow
the tool t ostop rotating before setting i tdown.
MAINT£NANCE
A WARNING: To reduce the risk of injury, turn unit off and
disconnect it from power source before installing and removing
accessories, before adjusting or when making repairs. Before
reconnecting the tool, depress and release the trigger switch
to ensure that the tool is off. An accidental start-up can cause
injury.
Cleaning
A WARNING: Blow dirt and dust out of all air vents with clean, dry air
at least once a week. To minimize the risk of eye injury, always wear
ANSI Z87.1 approved eye protection when performing this.
i_,WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the tool," never immerse any part of the tool into a liquid.
Accessories
_ WARNING: Since accessories, other than those offered by
D_-/WALT,have not been tested with this product, use of such
accessories with this tool could be hazardous. To reduce the risk of
injury, only D,£WALTrecommended accessories should be used with
this product.
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center. If you
need assistance in locating any accessory, please contact DEWALT
Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286,
call 1-800-4-DL:.WALT (1-800-433-9258) or visit our website: www.
dewalt.com.
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and replacement) should
be performed by a DEiWALT factory service center, a DEWALT
authorized service center or other qualified service personnel. Always
use identical replacement parts.
Register Online
Thank you for your purchase. Register your product now for:
, WARRANTY SERVICE: Registering your product will help you
obtain more efficient warranty service in case there is a problem
with your product.
18