Table of Contents
Advertisement
Using AT Commands to Configure Your Modem
1.
Run Phone Tools or use your favorite communications program and open the program's terminal
window.
2.
To configure the modem for a specific country, type
then press
The message
Enter.
3.
To verify the change, type
example:
Country
AT Command
Euro/NAM
AT%T19,0,34 (default)
4.
The complete list of country codes can be found on the Multi-Tech Web site at
http://www.multitech.com/GlobalModem/config.
Dial-Up Networking
Dial-Up Networking
Dial-Up Networking
Dial-Up Networking
Before you can connect to the Internet, you must set up a remote-node client program, known as Dial-Up
Networking in Windows. Dial-Up Networking establishes your connection to your ISP's (Internet Service
Provider) server, which is the shared computer that manages calls from clients (your computer and other
clients' computers) to the Internet. Most, if not all, Windows browsers start Dial-Up Networking
automatically when you open them after you have setup your PC for Dial-Up Networking.
Many ISPs provide a program that will install and configure Dial-Up Networking automatically for you. If
this program was not provided, contact your ISP for instructions. You can also find Dial-Up Networking
information in your Windows operating system online help or printed documentation.
MT5634ZLX, MT5634ZLXI, MT5634ZLX/FE User Guide
displays.
OK
, and then press
ATI9
Enter
Result code
52
where nn is the country code, and
AT%T19,0,nn,
. The country code is displayed, as in this
Chapter 2 – Installation
12
Advertisement
Table of Contents
