Solution Strainer; Changing Brush Motors; Greasing Axle - Windsor SCENX326 10052340 Operating Instructions Manual

Solution Strainer

The solution strainer is located in front of the left front
wheel. The solution strainer protects the solenoid valve
from debris. If there is little or no solution flow to the
ground, check the strainer for debris. Drain the solution
tank and clean the solution strainer. To remove the
strainer, turn the bottom part of the strainer counter-
clockwise until the bottom is separated. Clean out the
debris from the wire mesh and re-assemble. Make sure
the O-ring gasket is in place when re-assembled
Brush Motor
Do not use a pressure washer to clean around the
brush motors. Use tap pressure only.

Changing Brush Motors

1. With the scrub deck in the stored position, discon-
nect brush motor wiring connector from harness.
2. Remove shrouds from scrub deck to access and
remove scrub brushes or pad drivers.
3. Remove retaining bolt, lock washer, flat washer
and star drive from brush motor shaft.
4. Remove 4 brush motor mounting bolts located
under scrub deck.
5. Remove brush motor.
6. Reverse steps to install.
Brush Motor Carbon Brush Replacement
1. Scribe alignment mark on motor barrel to motor
cap. Remove two bolts.
2. Remove end cap from motor.
NOTE: Motors contain two wave washers in cap. Do
not lose these.
3. Release brush from spring tension. Remove screw
connecting brush wire lead to brush holder. Clean
brush holder to insure free movement.
4. Retract spring and install new brush. Install
connector screw and lead.
5. When all new brushes are installed. Place all in
retracted position, held into brush holder by spring
tension.
6. Carefully place end cap onto bearing on motor
shaft.
86400430 Operators Manual - Cutter Euro 36V Deluxe
NOTE: Use care to assure wave washer alignment.
7. With end cap in partially installed position, release
all brushes to contact position with motor commu-
tator.
NOTE: Failure to insure all brushes are released will
result in motor failure.
8. Reset end cap and realign with scribe marks on
motor barrel. Reinstall the two attach bolts from
cap into base.
NOTE: Maintain alignment between motor barrel
base and cap.

Greasing Axle

1-2 Strokes Mobiltemp®78 or compatible clay-based or
calcium-based grease.
NOTE: Use hand operated grease gun only.
Maintenance
27