Canon XA30 Instruction Manual page 44

Recording Movies and Photos
Intelligent IS
Intelligent IS allows the camcorder to select the best image stabilization option based on your
shooting method. The Intelligent IS icon will change to one of the following icons. In
modes, you can set the image stabilization mode manually (A 66).
Most general situations; Zooming out (zooming toward T); Following
44
subjects at a distance moving left or right
Zooming in (zooming toward S)
Close-up of a subject
Remaining stationary, such as when using a tripod
* With the p
automatically as one of the Intelligent IS modes.
IMPORTANT
• Observe the following precautions while the ACCESS indicator is on or flashing. Failing to do so
may result in permanent data loss or damage to the memory card.
- Do not open the double memory card slot cover.
- Do not disconnect the power source or turn off the camcorder.
- Do not change the camcorder's operating mode.
• Be sure to save your recordings regularly (A 118), especially after making important recordings.
Canon shall not be liable for any loss or corruption of data.
NOTES
• The START/STOP button on the handle unit has a lock lever to prevent accidental operation. Set the
lock lever to C in cases such as when you do not want a recording inadvertently paused or do not
plan to use this START/STOP button. Return the lever to its previous position to enable use of the
START/STOP button again.
• When you set the q
terminal (
recording commands through a connection via the HD/SD-SDI terminal (
terminal, if you start or stop recording with the camcorder, the connected device will also start or
stop recording.
• When the camcorder switches form recording on one memory card to another during relay
recording, the video will be recorded as two separate relay scenes. With the software Data Import
Utility, you can join relay scenes recorded on both memory cards as a single scene and save it on a
computer (A 118).
• For scenes with a long recording time, the video (stream) file in a scene will be split approximately
every 4 GB. Even in such case, playback will be continuous. With the software Data Import Utility,
you can join such split files into a single scene and save it on a computer (A 118).
• When recording in bright places, it may be difficult to use the OLED screen. In such cases, you can
adjust the brightness of the OLED screen with the q
Alternatively, you can also use the viewfinder (A 25).
Shooting method
>
[Intelligent IS] setting, you can select whether Powered IS can be set
>
[Rec Command] setting to [i On] and you use the HD/SD-SDI
only) or HDMI terminal to connect the camcorder to a device capable of receiving
Icon
Ä (Dynamic IS)
È (Powered IS)*
 (Macro IS)
à (Tripod mode)
only) or HDMI
>
[OLED/VF Brightness] setting.
and