Oregon Scientific RRM968P User Manual page 13

TROUBLESHOOTING GUIDE - RRM968P/ RRM968PU
Trouble
Reception icon "Antenna" is not shown
Displayed Temperature data is different from other
measuring instruments
- Clock time is not correctly set; and/or
- Reception icon "Antenna" displays as "No
reception"
The projection LED does not go on when AC/DC
adapter is installed
The unit is reset when SNOOZE button is pressed
Warning:
- For other cases not listed in the above, feel free to contact our help line
- Do not dissemble the unit. This will void the warranty
Possible Cause
Auto-reception of clock radio signal has been
disabled
(1) The measurement method is different
(2) The area under evaluation is different or being
influenced by climate
The clock radio signal is not received because:
- Electromagnetic interference exist, or the Main
Unit is located within reinforced concrete wall or
shadowed area location
- Orientation of placement is not at optimum
position for reception of clock radio signal
Projection-On button is slid to the Off-position
Batteries are being discharged
13
Remedy
Enable this function by following the
instructions in the User's Manual
(1) U s e t h e s a m e i n s t r u m e n t s w i t h
consideration of the tolerance of readings
(1) Place the 2 instruments very closely for a
time period (no less then 30 minutes),
avoiding direct light and air movements
- Locate the Main Unit far from PC, mobile phone
etc and re-locate it near the window sill. Wait at
least 24 hours (note: during night-time signal is
less attenuate particularly after raining)
- The clock radio signal is searched at 1:00,
2:00, 3:00, 9:00, 15:00, 21:00 every day
automatically
- To force the signal reception please refer to
instructions in the User's manual
Slide the Projection-On button to the On-
position
Replace with new batteries