Blade Attachment; Blade Installation; Light Fixture Installation - Revolutions Solaris Owner's Manual

WARNING: To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring.
NOTE: If you are not sure the electrical box and fan are grounded, contact a licensed electrician for advice. They
must be grounded for safe operation.
WARNING: Each wire nut (wire connector) supplied with this fan is designed to accept up to one 12 gauge house
wire and two wire from the fan. If you have larger than 12 gauge house wiring or more than one house wire to
connect to the fan wiring, consult an electrician for the proper size wire nut to use.
WARNING: Check to see that all connections are tight, and that no bare wire is visible at the wire nuts.

Blade Installation

1. Attach blade brackets to blades using the blade bracket screws (1), fabric washers (2), and nuts (3)
provided (Fig.7A).
2. Check the motor for plastic shipping stabilizer tabs (1), and remove them if they are present.
3. Attach blade assembly to motor using the provided motor screws. To attach the blade assembly, rotate
the installation window on the bottom of the light kit. Install the provided motor screws through the
installation window and into the motor. Rotate the installation window to install each blade assembly to
the motor.
4. Tighten screws securely (Fig. 7B).
Fig. 7A

Light Fixture Installation

Fig. 8A
Install light bulbs (Fig. 8A). Slide fan pull chain through
the hole in the glass bowl and the metal cap (Fig. 8B).
Fig. 7B
Fig. 8B
9
ME008-01 11/11/2014
Fig. 8C
Assemble decorative fob and extension
chains from hardware bag to the fan
pull chains by inserting end of chain
into chain coupling. Confirm chains are
held by lightly pulling both chains in
coupling (Fig. 8C).