Hugger Style - Revolutions Solaris Owner's Manual

2. Tighten the two downrod setscrews. Some models have locknuts for the setscrew to ensure the setscrew
is fully seated against the down rod. It is necessary to back off the locknut until it contacts the setscrew
head prior to tightening the setscrew. When the setscrew is tightened against the downrod, the locknut
should then be tightened against the connector yoke. Repeat for both (Fig. 3).
3. Tighten the motor setscrew. Check the strength of the connection (pre-tightened at the factory) by
holding the motor housing in position and turning the downrod counter clockwise. If this connection
slips, retighten the motor setscrew and locknut. Follow the same procedure mentioned above for the
downrod setscrews.
4. Install ball into hanger bracket opening. The tab opposite of the hanger bracket opening should fit in
slot on ball (Fig. 4).
5. Make wire connections (refer to section titled "Electrical Connections").
6. Slide the canopy up and fasten to the hanger bracket with the four screws provided.
WARNING: To avoid damaging the blade arms and blades, do not install either until the fan is fastened
to the ceiling. To avoid motor shift, handle fan by downrod or switch housing only.
Fig. 3

Hugger Style

1. Fasten the canopy directly to the top of the fan motor housing with the three screws provided. (The
downrod and ball are not used for this installation) (Fig. 5A). If a metal ring washer with three holes is
provided, use it to install the canopy.
2. Hang the canopy (with the fan motor housing attached) from the tab on the hanger bracket (Fig. 5B).
This will allow you to make the electrical connections without having to hold the fan up.
3. Make the wire connections (refer to the section entitled "Electrical Connections").
4. Put two screws in the hanger bracket, leaving them partially out (Fig. 5C).
5. Place the canopy up on the hanger bracket by inserting the slotted opening of the canopy on the screws
(Fig. 5D).
6. Insert the remaining screws through the remaining canopy holes and tighten all four screws.
WARNING: Failure to completely tighten the screws in step 1 could result in fan loosening and possibly falling.
Fig. 5A
Fan Motor
Housing
Downrod Screw
Motor Set Screw
Fig. 5B
Screw
Tab
Canopy
ME008-01
Fig. 4
Tab
Ball
Ball Slot
Fig. 5D
Fig. 5C
7
11/11/2014
Hanger Bracket
Slotted
Hole